How To Check Glow Plugs On 6.6 Duramax

A diesel engine relies on heat to initiate the combustion process. In order to produce heat, the diesel fuel must be injected into the hot air in the cylinders. The glow plugs are electrically heated, and when they reach a certain temperature, they will start to glow. This will heat up the air in the cylinders, which will then start the combustion process.

How To Check Glow Plugs On 6.6 Duramax

A diesel engine relies on heat to ignite the fuel. The heat is created by the compression of the air in the cylinders. The diesel engine has glow plugs that help start the engine by providing heat to the cylinders. The plugs are similar to spark plugs, but they don’t create a spark. They get hot enough to start the fuel burning. The most common way to check the glow plugs on a Duramax diesel engine is to remove the valve cover and look at

– Socket wrench set – Ratchet – Extension – Glow plug socket – Hex key – Paper clip or wire

  • Use a voltage meter to test each plug for resistance (should be less than 10 ohms)
  • If a plug is not functioning correctly, replace it
  • Remove the four glow plugs
  • Remove the intake manifold cover

-Check the condition of the glow plugs by inspecting for cracks, damage, or carbon build-up -Check the electrical connectors and plugs for tightness and corrosion -Check the glow plug resistor for continuity -Check the wiring harness for damage


Frequently Asked Questions

How Do You Troubleshoot Glow Plugs?

The most common issue with glow plugs is that they simply need to be replaced. A less common issue is that the glow plug controller may need to be replaced. Occasionally, there is an issue with the wiring or the plugs themselves. In order to troubleshoot glow plugs, one should check the following: the fuse, the power to the glow plug controller, the ground, the resistance of the plugs, and finally, the condition of the plugs themselves.

How Do You Test A Glow Plug Module Lb7?

Testing a glow plug module lb7 involves connecting the module to a power source and using a test light to check for continuity between the terminals. If continuity is present, the module is likely functioning correctly. If no continuity is present, the module may need to be replaced.

How Do You Test A Glow Plug Module With A Multimeter?

Testing a glow plug module with a multimeter is fairly simple. First, remove the connector from the glow plug module. Then, use the black lead of the multimeter to connect to the negative terminal of the battery and use the red lead of the multimeter to touch each connector on the glow plug module. If there is continuity between any of the connectors, then the glow plug module is defective.

Does A Glow Plug Control Module Need To Be Programmed?

Yes, a glow plug control module needs to be programmed in order to function properly.

How Do You Test A Glow Plug Without Removing It?

One way to test a glow plug without removing it is to measure the resistance between the two terminals with an ohmmeter. A low resistance means that the glow plug is working properly, while a high resistance means that it is not.

How Do You Check The Glow Plug Module On A Duramax?

To check the glow plug module on a Duramax, remove the cover from the module and visually inspect the contacts for damage. If there is any damage, replace the module.


In Closing

To check the glow plugs on a 6.6 Duramax, remove the valve cover and look for the six glow plug connectors. Use a test light to probe each connector for power. If one or more of the connectors is not getting power, that glow plug is bad and will need to be replaced.

Leave a Reply

Your email address will not be published. Required fields are marked *